Filter
Top Products
3.6 NON POWER STEERING CARS: Locate
your lower bracket assembly from the kit. The
end with the small 90-degree bracket mounts to
the idler bracket (standard on AC equipped cars)
or to new idler bracket (supplied with kit for non-
AC, non-PS cars). Use the new, longer 10mm
bolt provided to attach this bracket to the engine
(Review figure 3.4 for bolt location).
4.0 POWERCARD
4.1 The Powercard will be installed in the pas-
senger (right hand) foot well. Remove the kick
panel trim by removing the plastic fastener
securing the top, front portion of the panel. Use a
small screwdriver to pull out the center section
and then pull the whole fastener out. There is
also a push in fastener in the center of the panel.
Slip your fingers up behind the panel and gently
pull out on the center until it pops free. Once the
center fastener is free, slide the panel out from
under the door sill trim and set it aside. Remove
the forward two screws from the door sill trim to
allow easy removal and reinstallation of the car-
pet. Remove the floor mat and pull back the car-
pet to expose a large metal plate. Using a 10mm
socket, remove the four nuts and one bolt that
secure the plate to the car. Remove the plate to
gain access to the Electronic Control Unit (ECU).
Supercharger Installation Instructions
999-156 -6- Revised 1/07
Illustration 4.1
Illustration 4.1 con’t