Filter
Top Products
CONVENIENCEGETTING STARTED DRIVING CONTROLS MEDIA CENTER COMFORT NAVIGATION
convenience
41
Automatic Drive Positioner Memory System
Driver’s Seat, Steering & Outside Mirrors
When programmed, the Automatic Drive Positioner can adjust the driver’s seat,
steering column, and outside mirrors to two memorized positions.
To Set Customized Seat, Steering, and Mirror Position Memory:
1 Push the ignition switch to the ON position. Keep the transmission in P (PARK).
2 Adjust the driver’s seat, steering wheel, and outside mirrors to the
desired positions.
3 Press the SET button.
4 Within 5 seconds, press Memory button 1 or 2 and hold down for at least 1
second. The indicator light on the Memory button you select will illuminate
solid for approximately 5 seconds. Seat/steering/mirror memory is now
set to your preference.
5 Link the seat/steering/mirror memory to your Intelligent Key. While
the indicator light on the Memory button is illuminated (see step 4,
above), press the UNLOCK
button on your Intelligent Key. The driver’s
seat, steering column and outside mirrors will move to the memorized
position with the indicator light flashing, and then the light will stay on for
approximately 5 seconds. The memory is now matched to the Intelligent
Key. You may set the second seat/steering/mirror memory positions to
your other Intelligent Key by repeating the steps above.
Note: After step 5 is performed one time to link the seat/steering/mirror memory to your
Intelligent Key, you DO NOT need to perform this step again if new seat/steering/mirror memory
positions are saved in the future. New memory positions are automatically linked to your
Intelligent Key after step 5 is performed one time.
Entry/Exit Function
The Entry/Exit function is designed so that the driver’s seat will automatically
move BACKWARD and the steering wheel UP to ease entering and exiting the vehicle.
This feature is activated when the ignition switch is in the LOCK (OFF) position
and the driver’s door is opened.