Filter
Top Products
N When a vehicle IS detected ahead of you in the lane, the set speed
will adjust to maintain the set distance.
To Set Fixed Speed-Control Cruise:
1 While Cruise Control is OFF, press the CRUISE ON/OFF button and hold
down for more than 1.5 seconds. The
indicator light (located in the
tachometer) will illuminate.
2 Accelerate to the desired speed.
3 Push DOWN on the COAST/SET switch and release it. The
indicator
light will illuminate. Cruise Control will be set to the desired speed.
Note: There are certain conditions under which vehicle-to-vehicle distance-control and/or fixed speed-
control cruise cannot be set or will automatically cancel. Three such conditions are shown below:
N When rain, snow, or dirt cover the system sensor (located in the front bumper opening).
N When the windshield wiper is operated at low or high speed.
N When strong light shines directly on the front of the vehicle (i.e., during sunrise or sunset).
To Switch Between Two Cruise Control Modes:
When one of the two cruise modes is in use, you must first turn the system
OFF and then ON again (as instructed in this section) to select the other Cruise
Control mode.
16
Note: If your vehicle moves closer to the vehicle ahead due to rapid deceleration of that vehicle, or
if another vehicle cuts into the traveling lane, a warning chime will sound and the vehicle distance
indicator light will blink. Depress the brake pedal and slow your vehicle to maintain a safe vehicle
distance. The Intelligent Cruise Control system will not automatically brake the vehicle to a stop.