Filter
Top Products
© 2003 Directed Electronics, Inc. Vista, CA 23
TO EXIT THE LEARN ROUTINE, DO ONE OF THE FOLLOWING:
■ Close the open door.
■ Turn the ignition on.
■ No activity for longer than 15 seconds.
■ Press the Valet/program switch too many times.
feature descriptions
1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system will only arm when the transmitter is
used. When set to passive arming, the system will arm automatically 30 seconds after the last door is closed. To
alert the consumer of passive arming, the siren will chirp and the parking lights will flash 30 seconds after the
door is closed.
2 AUDIBLE ARM/DISARM CONFIRMATION ON/OFF: This feature controls the chirps that confirm the arming and
disarming of the system. In the ON setting (default) the siren will provide audible confirmation when arming
and disarming the system. If programmed to the OFF position no siren chirps will be heard when arming and
disarming.
3 SIREN DURATION 30/60 SECONDS: In the default setting, the full triggered sequence will continue when trig-
gered for 30 seconds. This can be changed to 60 seconds in the system features learn routine.
4 DOOR TRIGGER INSTANT/DELAYED: In the instant (default) setting, if a door is opened while the security
system is armed the system will trigger immediately. In the delayed setting there is a 15-second delay before the
doors will trigger the system. This allows the user 15 seconds to disarm the system after a door is opened without
the factory transmitter.
5 DOOR TRIGGER ERROR CHIRP ON/OFF: With the door trigger error chirp programmed off, the system will not
report an invalid zone on arming when the door trigger wire is active. This eliminates the extra chirps that occur
when interfacing with vehicles that have exceptionally long dome light delay circuits.
6 SENSOR SHUNT ZONES 2 and 4/ALL ZONES: In the default setting all sensors, with the exception of the door
zone, will be bypassed when a trigger is grounded three seconds after the trunk is opened (i.e. when there is a
(+) pulse on the WHITE/BLUE wire). If this feature is programmed to the all zones setting, all zones, including
the doors, will be bypassed when the trunk is opened with the factory transmitter.
7 PANIC/AUXILIARY OUTPUT: When this feature is programmed for Panic Mode (default setting), pressing the
lock button on the factory transmitter twice within three seconds will trigger Panic Mode. In this setting, the
H1/12 RED/WHITE wire becomes a delayed accessory output. This wire will provide (-) ground when the ignition
is turned off and will continue to output (-) ground until a door is opened. This can be used to energize the