Filter
Top Products
16 © 2003 Directed Electronics, Inc. Vista, CA
H1/11 RED (+) 12V CONSTANT POWER INPUT
Before connecting this wire, remove the supplied fuse. Connect to the positive battery terminal or the constant
12V supply to the ignition switch.
NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15A fuse
in the harness for this purpose. This fuse protects the module itself.
H1/12 RED/WHITE PROGRAMMABLE (-) 200 mA AUXILIARY CHANNEL/DELAYED ACCESSORY OUTPUT
If programmed for the default setting, this wire will provide a (-) pulse when the lock button on the factory
transmitter is pressed twice within three seconds. This output can be used to control optional accessories. If pro-
grammed for delayed accessory output, this wire will provide (-) ground when the ignition is turned off and will
continue to output (-) ground until a door is opened and then closed. This can be used to energize the acces-
sory circuit in the vehicle to keep the radio and other accessories on after the ignition is turned off.
IMPORTANT! Never use this wire to drive anything except a relay or a low-current input! This
transistorized output can only supply (-) 200 mA, and connecting directly to a solenoid, motor, or
other high-current device will cause the module to fail.
plug-in harnesses
The LED operates at 2V DC. Make sure the LED wires are not shorted to ground because the LED will be damaged.
The LED fits into a
9
/32-inch mounting hole. Be sure to check for clearance prior to drilling the mounting hole.
The Valet/program switch should be accessible from the driver’s seat. It plugs into the 2-pin blue port of the
control module. Since the system features Valet by remote, the Valet switch can be well hidden. Consider how
the switch will be used before choosing a mounting location. Check for rear clearance before drilling a
9
/32-inch
hole and mounting the switch. The GRAY wire in the two-pin plug may also be used as a (+) Ghost Switch input
and can be connected to any positive (+) switch in the vehicle (see Feature 9 in the Feature Descriptions section
of this guide).
NOTE: Please note for the customer the location of the Valet/program switch in the section pro-
vided in the Owner’s Guide.
valet/program switch, 2-pin blue plug
super-bright LED, 2-pin white plug