Filter
Top Products
Whereis® Navigator Installation Guide for HP iPaq with In-Built GPS - version 2.5 Page 5
1.3 Equipment Required
The following important components are required to operate Whereis® Navigator:
A HP iPaq with an in-built GPS Receiver, ie hw6515 or hw6965.
GPRS data communications must be enabled to use this service
1
. Please
contact your telecommunications company to configure or enable data
communications on your phone.
The Whereis® Navigator for HP iPaq devices with in-built GPS.
A unique license key
for each mobile device you require. This is included
with your new HP iPaq and you need to visit
http://navigator.whereis.com
to register. You should keep this number and any Whereis® Navigator
CD in a safe place should you need to reinstall.
Please note that each license key has been configured to operate on one
device and if used on more than one device, may be automatically
disabled and you will need to contact customer care for re-activation
which may take up to 72 hours.
1.4 General Requirements
• At least 3.5 MB of free memory for application installation.
• We recommend an in-vehicle charger for your HP iPaq to ensure the best
battery performance.
• A quality vehicle-mount for your phone.
• We recommend performing a back-up of your device once you have
successfully installed and configured Whereis® Navigator. This will allow you
to restore your device configuration in the event of total battery loss and
device hard resets (consult your PocketPC user guide for assistance). The HP
iPaq has a back up utility which can be found under programs -> HP Backup
Utility.
1
Whereis® Navigator requires you are in mobile coverage to download routes. You do not require coverage once the route
is downloaded unless you deviate from the route and require a new route to automatically download.