Filter
Top Products
23
Display Description
*L xxxxx = Left K-factor (where xxxxx is valid from 0 to 20,000. These are in 10s. A
setting of 1234 would be a K-factor of 12,340)
*R xxxxx = Right K-factor (as above).
*A xxxxx = Left Fuel Flow Offset Frequency (Hz) for Analog Models Only
*B(b) xxxxx = Right Fuel Flow Offset Frequency (Hz) for Analog Models Only
*U x = Fuel Units are defined by the part number. Do not adjust these, as improper
burn indication will occur.
0 = Gallons
1 = Liters
2 = Lbs 5.8
3 = Lbs 6.7
4 = Kilograms
5 = Lbs 6.5
6 = Lbs 6.35
*E x = Engine Type:
0 = Single
1 = Twin
*C x = Low Flow Cutoff:
0 = Off
1 = On
NOTE: Will not display fuel flow until a rate of 50 pounds per hour is
reached.
O x = GPS/Output Type: Only used with Microflo-L, which selects the serial data
output type by GPS or Loran Manufacturer.
0 = none
1 = Allied Signal, KLN series
2 = AirData, used to communicate with a Shadin Airdata
computer
3 = Arnav, used to communicate with most Arnav Loran or GPS
4 = Trimble, used to communicate with most Trimble Loran
or GPS
5 = Generic, used to communicate with most Garmin GPS
I X = Loran Input:
0 = Off
1 = On
D(d) x = Endurance Warning Time:
0 = 45 minutes
1 = 5 minutes
2 = 10 minutes
3 = 20 minutes
4 = 30 minutes
F x = Filter Type:
0 = Injector
1 = Carburetor, for engines equipped with a carburetor
W(
u
) x = Ignore Loran Warnings
0 = No (default) setting used with Shadin Flow Meter. With
GPS, set to zero (0).
1 = Ignore Loran Warnings. Used with Foster Loran only.
S xxxx = Low Fuel Level: Displayed in same units of measure as the flow rate.
* = Group 1 information ( ) = actual letter display. All others displayed as shown