Filter
Top Products
21
The values displayed can be adjusted with the ADD/FULL toggle
switch. ADD increments the value, and FULL decrements the
value. As you hold ADD or FULL, the scrolling rate will increase
up to a maximum speed.
If you wish to jump directly into the fastest scrolling speed, while
holding the ADD/FULL toggle switch, press the fuel USED or fuel
REM button.
Once the desired values are selected, press and hold the
TEST/ENTER button while the upper window displays a count
down from 5 to 1. When the lower left window displays “SET,”
release the TEST/ENTER button.
Note: It is recommended that you leave the unit powered up for at
least one minute before turning the unit off. Reset switches 1 and 2
to Operate Mode (F,F) and reboot (Power ON). Then confirm the
settings. The Manual Entry Pages will be displayed as follows.
Symbols in ( ) represent 7 segment characters actually displayed.
Field K-factor adjust for Software Versions 60.08.72+
1. Remove the Microflo-L from the instrument panel.
2. Remove the red label from the right side of the Microflo-L
and save it to be put back in place after the adjustment is
complete.
3. With a small, flat blade screwdriver change the second
hexadecimal switch (SW2) from the face of the Microflo-L
from position “F” to position “E”.
4. Reconnect the unit to the aircraft harness and turn the
aircraft master switch on. An “L” for the left engine will
appear on the left side of the left window, and the K-factor
minus the least significant digit on the right side of the
window.