Filter
Top Products
To restore user data from a UserData card to the GPS 155:
1. Install the UserData card.
2. Turn the GPS 155 on using
B
.
3. Use
O
O
to highlight ‘Restore user data?’ and press
E
.
The GPS 155 will ask you which type of data to replace. You may choose check-
lists, scheduler messages, user waypoints, proximity waypoints, routes, waypoint
comments or all data.
4. Use
K
to select the type of data to replace.
You may either replace or update the information in the database. Replacing the
data will replace ALL user data with the data from the card. Updating the data will
not delete unrelated material, it will only change what is necessary to use the data
received from the UserData card.
5. Use
O
to select either ‘Replace?’ or ‘Update?’.
6. Press
E
to begin transferring data to the GPS 155. The GPS 155 will now transfer all
of the data requested. This may take several minutes.
7. To perform additional data transfer types, repeat steps 4- 6. Otherwise, press
E.
8. Turn the GPS 155 off and replace the UserData card with a NavData® card. The GPS
155 is now ready for normal operation.
95
APPENDIX A
NavData Card Operation
The GPS 155 must be turned off to remove and
install the NavData card.
Restoring data from a user data card.
155man (GOOD) 7/24/98 1:57 PM Page 95