Filter
Top Products
Appendix A
NavData and UserData Installation and Operation
NavData® and UserData Card installation and operation
The NavData® card supplied with your GPS 155 can be installed or removed
ONLY when the GPS 155 is turned off. Insert the card with the thumb tab at the top,
and the beveled corner on the bottom right.
The UserData card can be used to make a backup of user waypoints, routes,
checklists, proximity alarms, etc. for later reference and use. The UserData card can
also be used to transfer the same information to another GPS 155.
To save the user data to the UserData card:
1. Install the UserData card.
2. Turn the GPS 155 on using
B
.
3. Use
O
to highlight ‘Save user data?’.
4. Press
E
.
The message ‘Saving to card’ is displayed while the GPS 155 transfers all user data
to the UserData card. It may take several minutes to complete the transfer. When all
user data is transferred, the GPS 155 will instruct you to turn the unit off, remove the
user card and insert the Jeppesen NavData® card. After this is complete, the GPS 155
is ready for normal operation.
94
APPENDIX A
NavData Card Operation
UserData Card Installation.
UserData Transfer Page.
155man (GOOD) 7/24/98 1:57 PM Page 94