Filter
Top Products
22 c510 Owner’s Manual
APPENDIX
APPENDIX
Mounting on Your Dashboard
Use the enclosed mounting disk to
mount your unit to the dashboard and to
comply with certain state regulations.
Important: The permanent mounting
adhesive is extremely difficult to remove
after it is installed.
To install the
mounting disk:
1. Clean and dry the dashboard where
you are placing the disk.
2. Remove the backing from the
permanent mounting adhesive on the
bottom of the disk.
3. Place the disk on the dashboard.
4. Place the suction cup mount on top of
the disk. Flip the lever down (toward
the disk).
Resetting Your c510
If your unit locks up (freezes up), press
and hold the
Power button to turn off
the unit. Then turn the unit back on. If
this does not help, reset your c510.
To reset the c510:
1. Place your thumb nail in the groove
located under the Garmin logo on the
faceplate.
2. Gently pull off
the faceplate.
3. Press the
Reset button.
4. Connect the
c510 to a
power source using the power cable.
The c510 should automatically turn
back on and operate normally.
NOTE: If you need to reset your unit
often, update the system software.
See page 25 for information about
updating the software.
Disk
Suction
cup
mount
Lever
Reset button
Power buttonFaceplate