Filter
Top Products
3. OPERATION
23
2. Press the W or X key to adjust the brilliance (available range: 1 to 50).
You can also adjust the brilliance by pressing the /BRILL key repeatedly.
3. Press the S or T key to close the window.
Note 1: If you turn off the display unit with the minimum brilliance, you may become difficult to
watch the screen because of the ambient light at the next start. In this case, press the /BRILL
key repeatedly.
Note 2: When you use the display unit for FAR-21x7 series, you can adjust the brilliance from the
FAR-21x7 series. (see paragraph 3.6.2.)
3.4 How to Select the Source for Main Picture
Select the signal to display on the entire screen as follows:
1. Press the DISP key to show the DISP selection window.
The signal names are shown as you customized at paragraph 2.3.2 on the window.This win-
dow disappears if there is no operation for five seconds.
DISP selection window (Default setting)
2. Press the S or T key to select a signal.
You can also select the signal by pressing the DISP key continuously.
[RGB]: The signal from the RGB port is displayed.
[DVI1], [DVI2]: The signal from the selected DVI port is displayed.
[VIDEO1] - [VIDEO3]: The external video from the selected VIDEO port is displayed.
3. Press the W or X key to close the window.
The name of the selected signal appears at the right top corner for five seconds after the DISP
selection window disappears. If there is no signal, "NO SIGNAL" appears.
3.5 How to Select the Source for the PIP Window
Select the source for the PIP (picture-in-picture) window as follows. The PIP window is available
on the RGB, DVI1 or DVI2 display.
RGB
DVI1
DVI2
VIDEO1
VIDEO2
VIDEO3
PIP window