Filter
Top Products
25
TAPING WHIP ANTENNA
After inserting the whip antenna to the antenna base, tape the antenna base and whip antenna
with self-vulcanizing tape and vinyl tape to reinforce the whip antenna.
1. Wrap the antenna junction point with butyl 15 tape or the equivalent.
How to wrap
1) Pull the tape to be about two times in length and wind it up, overlapping by 1/2 the width of
the tape.
2) Wrap from bottom to top, i.e., from right to left as in the picture below.
Butyl tape
Whip antenna
Base
Antenna
3) Wrap the tape from the base to a point about 60 mm, and then back to the base.
Keep tension on edge of tape, using finger to hold tape. Then, squeeze edges of tape with
thumb and index finger.
Wrap approx.
60 mm
2. Completely cover the butyl rubber tape with white vinyl tape, wrapping from the base to the
last wind of butyl tape and then back to the base.
How to wrap
1) Being careful not to pull the tape too tightly, wind tape, overlaping by approx. 1/3 of tape
width.
2) Squeeze edges of tape with thumb and index finger.
White vinyl tape