Filter
Top Products
4-3
Installation of DGPS receiver
Procedure
1. Dismount chassis assembly from panel/chassis assembly by disconnecting the
connector and PH8P from J8 on MAIN Board shown in the figure below.
A
(P)MAIN
A
J8
J7
View
Remove
two ties.
Cable w/8P
connector
Connector
MAIN Board
14P0311B
Panel assembly
ANLG Board
14P0313B
Figure 4-2 Dismounting chassis assembly
2. Dismount heat sink from chassis assembly by unfastening three screws on the
ANLG board, loosening two screws at TR fixing plates and disconnecting the
connector of the mini pin coaxial cable.
ANLG Board
Screws (3 X 8), 3pcs.
Mini pin
coaxial cable
Heat Sink
TR fixing plate
Figure 4-3 Chassis assembly