Filter
Top Products
49
Error Possible Causes Remedies Page
The LCD shows “B ” and
“
H” blinking though a film
cartridge has been loaded
and the film cartridge
compartment cover has
been closed.
A cartridge has been
inserted, but the counter is
not displayed on the LCD.
The film will not wind on.
The shutter release won’t
trip.
The film cartridge
compartment cover cannot
be opened.
11
11
6
7
12
23
●
Open the film cartridge
compartment cover and check
the film cartridge status mark.
Are you using a film cartridge
with a white i mark or j.
●
Check to ascertain that the
batteries have been inserted
after the cartridge.
q “ D ” symbol is blinking
w Power switch is not on.
e “B ” is lit on the exposure
counter.
●
Are you attempting to open
the film cartridge cover in the
middle of a roll?
●
Use a film cartridge with a white
i mark or j.
●
The shot will not be taken if the
shutter was operated in this
condition. Remove the cartridge
without rewinding, and then
reload it again.
q Replace the battery with a new
one.
w Turn on the power by opening
the slide cover and set the
camera to the ready-to-shoot
state.
e Remove the film cartridge and
load an unused film cartridge or
a film cartridge with unexposed
frames remaining.
●
Rewind the film with the mid-roll
change button. When “ B ”
appears in the exposure counter,
unload the film cartridge.
ERRORS, POSSIBLE CAUSES, AND REMEDIES
During operation