Filter
Top Products
When trouble is suspected
31
WA
Never attempt to
disassemble, repair or
modify the product.
It could cause injury by
ignition or abnormal
movement.
You may hear the following noises or detect some
feeling as described below during operation. However,
these are not errors but inherent to the product so that
the service life, or others will not be affected.
• Clatters produced by the knead balls moving up or
down
• Noise of gears or motor during massaging movement
• Sound of rustling between the knead balls and the
cloth (particularly during KNEAD movement)
• Rattling noise during the TAPPING or WAVELET
movement (particularly during movement from the
shoulder to the back)
• Speed of massaging movement may vary during
KNEAD, TAPPING or WAVELET depending on the
force of reaction against kneads balls.
• Difference of noise after changing the “SPEED” setting
(Metallic noise during the slow speed)
• Beat from motor at application of load
• Noise released when the knead balls are moved fore
and after automatically to adjust to the person during
the AUTO COURSE (Clicks)
• Breathing noise of exhaust during pneumatic
movement
• Sound produced from inflating air bags
Phenomenon Inspection Point Remedy Reference Page
Is the power cord plug inserted
properly?
Insert the plug in the receptacle
securely.
8, 16, 24
Check if the power switch at
the back of arm rest is turned
on.
Turn ON the power switch. 8, 16, 24
Failure to start
Did you specify massaging
functions by pressing
corresponding switches for the
AUTO COURSE and the
selective function?
Select desirable functions by
pushing corresponding
switches.
16, 24
Check the back rest for
interference with the wall or
other obstruction.
Move the chair to avoid
obstruction.
Turn OFF the power switch
located at the back of arm chair
and back on again.
13, 16, 24
Interrupted
movement
(Remote control
is disabled.)
Check for excessive load.
(Excessive load on the knead
balls activates the safety
mechanism to stop all
functions.)
Separate your body from the
back rest. Turn “OFF” the
power switch located at the
back of arm chair and back
“ON” again. Try to set again
from the start.
8, 16, 24
WARNING