Filter
Top Products
Use of the AUTO COURSE (Operate the following with the remote controller lid closed)
17
5. Name of selected COURSE and a message are displayed
(for example, in case of “1. REJUVENATE” of “WHOLE
BODY” course). Operation of the AUTO COURSE and the
body shape detection start simultaneously.
6. During the body shape detection, the detection point is
indicated with the lamp and the detection level is shown
with the detection indicator.
7. Detection of shoulder position is conducted automatically
following the body shape detection.
8. As the shoulder position is detected, you can finely
adjust the shoulder position. Push “ ” marks to
adjust while they are flickering. (It is indicated also with
the beep that sounds for approx. 5 seconds.)
• If you detect the body shape by pressing the “START” button, it is
stored in the memory till the massaging is terminated. To change
the body shape after it was stored, press the “START/RESET”
button and, after the cycle is completed, start again.
* When nobody is sitting or it failed to detect the body shape, “CAN
NOT DETECT BODY SHAPE” is displayed. Push the COURSE
button once again, and retry the body shape detection.
AUTO
WHOLE
SHOLDER
WAIST
7 MIN
STRENGTH
ADJUST
SHOLDER
UP
DOWN
AIR
WHOLE BODY
During
“POINT NAVI”
WHOLE BODY
Working
“POINT NAVI”
WHOLE BODY
Searching
Your Shoulder
WHOLE BODY
Adjust Roller
for Shoulder
CAN NOT DETECT BODY SHAPE
Press
the course mode
again
COURSE