Filter
Top Products
Preparation before use
13
Place of installation
Secure sufficient spaces around the chair.
* Request: As the back rest is reclined, the foot rest is turned up
at the opposite end. Minimum 50 cm of spaces must
be secured both at the front and the back of the chair.
* Request: Bottom of the chair may damage the tatami mattress
or floor. It is recommended to spread a piece of
mattress under the chair.
Changing the place of installation
Hold down on the top of the back rest using the castors as the fulcrum.
Front part of the chair will be lifted. Move the chair in this position.
CAUTION
•
Do not attempt to move the chair while a person or object sitting
on the seat. There is risk of upset.
•
Where the floor surface is not hard enough, the chair should not
be moved using the castors or by dragging directly on the floor.
•
Do not hold the seat or foot rest to move the chair.
•
Front part of the chair is rather heavy. Take sufficient care when
lifting the front part of the chair.
Grounding connection
Securely connect the grounding cable at the
chair.
Unless the grounding cable is
installed, it could cause electrical
shocks when the earth leakage
occurs. Consult your dealer to
install the grounding cable.
When the grounding terminal is provided at
the wall receptacle
• Extend the grounding cable
from the grounding terminal
on the chair main unit to that
on the receptacle.
Gas pipe … There is risk of explosion or
ignition.
Telephone cable or lightning rod … It is
dangerous when struck by lightning.
Water pipe … Earth connection is not
established if plastic pipes are connected
on the way.
When the grounding terminal is not provided
at the wall receptacle
• Consult your dealer or electrical work
contractor for the installation of grounding
cable. (Class 3 connection. Service is provided
on the charge basis.)
CAUTION
Do not connect the grounding cable
at the followings:
Castors
Grounding cable
50 cm or more
50 cm or more