Filter
Top Products
• To tow a vehicle on the rear wheels, it will be necessary to remove
the drive axles or disconnect the driveshaft. If the drive axles are
removed, the ends of the axle housing must be sealed to prevent the
loss of axle lubricant during towing.
• To tow a vehicle with an inoperative rear axle, the rear wheels
must be raised onto a dolly or tow the vehicle on the front wheels.
• If your vehicle is equipped with tow hooks, chains must be
fastened directly to the tow hooks on the vehicle.
• If your vehicle is not equipped with tow hooks, chains must be
routed under the bottom edge of the bumper with a protection bar to
protect the bumper, and attached to the vehicle chassis. Under no
circumstances is the vehicle to be lifted or towed by attaching chains
directly to the bumper.
Raising the vehicle
Never lift the vehicle by the bumper. When raising the vehicle, attach
chains to or place the jack(s) directly beneath the main structural
members of the vehicle.
Push-starting your vehicle
Avoid attempting to start a vehicle by pushing. Instead, use jumper
cables as described under Jump starting your vehicle in this chapter.
Vehicles with an automatic transmission cannot be started by pushing.
Roadside Emergencies
165