Filter
Top Products
23/42
SK5W7J-19A361-AA
© Copyright Ford 2005
2W7Z-16A901-AA
Rev Date- 8/29/05
To change the setting of an option (VSS system):
A. Press the door trim “Lock” switch to advance to the desired option (refer to the programming charts on the following
pages for the specific system that you are programming;
The horn will chirp a number of times to indicate which option is selected (i.e. Two chirps indicates that option number two
has been selected).
B. Press the door trim “Unlock” switch to change the setting of the option
The status LED indicates the setting of the option: LED ON indicates that the option is on, LED OFF indicates that the
option is off.
Note:
Pressing the door trim switch “lock button” while in transmitter learn mode will reset all options to their factory default settings,
except for the installer options and shock sensor settings. The system will respond by chirping the horn 4 times.
To advance to the next option bank:
A. At any point while in option programming, press and release the programming/override button to advance to the next
option bank.
The horn will chirp a number of times, indicating which option bank the system has entered (i.e. 5 chirps indicates that
the system is in option programming bank #2. Refer to the option programming chart to correlate the horn chirps to option
bank).
System Programming Instructions (Con’t)
2
CONTINUED
3
Shock sensor setting (not applicable to RKE or RKE/RMST systems)
The “Lite-touch” and “Full shock” sensor settings are always the first and second options, respectively, in the
first option bank. To change a shock sensor setting, follow these steps:
Remote control systems:
A. Enter option learn mode, option bank 1, as shown in step 2 of this section.
B. Go to option #1 for Lite-touch or option #2 for Full shock.
C. After the desired option is selected, pressing transmitter button 1 will increase sensitivity and pressing transmitter
button 2 will decrease sensitivity.
The system will chirp the horn each time a impact is detected that is greater than the current setting while the system is
in shock sensor setting mode.
VSS System
A. Make sure that the drivers window is rolled down.
B. Enter option learn mode, option bank 1, as shown in step 2 of this section.
C. Go to option #1 for Lite-touch or option #2 for Full shock.
D. Select the desired option and close all doors.
E. Press the door trim “Unlock” switch to increase sensitivity and pressing the door trim “Lock” switch to decrease sensitivity.
The system will chirp the horn each time a impact is detected that is greater than the current setting while the system is
in shock sensor setting mode.
F. Once the desired sensitivity is achieved, open a door to advance to the next option.
All Security Sytems:
A. The Full trigger shock sensor setting must be set within 10 increments of the least sensative setting and the “lite-touch”
setting must be set to within 30 increments of the least sensative setting.
B. Deviation from this setting recomendation introduces the potential of false alarm triggers, due to electrical or mechanical
interference.