Filter
Top Products
14/42
SK5W7J-19A361-AA
© Copyright Ford 2005
2W7Z-16A901-AA
Rev Date- 8/29/05
SECURILOCK INTERFACE KITS - 1L2Z-19G365-AB & 1S4Z-19G365-AB
Route the loop end of Securilock interface antenna ( B )
up along steering column to the area around the PATS
transceiver antenna coil. Then using the supplied small
tie wraps, secure the antenna harness to existing vehicle
wiring harnesses along the steering column allowing
enough slack for the antenna loop to go around the
PATS transceiver antenna.
NOTE: On LS and T-Bird, the ignition switch is mounted
on the dash to the right of the steering column. On those
vehicles, route the securilock interface antenna loop to
the ignition switch.
1
Following the directions on the supplied ampule of
adhesive primer ( D ), apply a thin coating primer to
entire transceiver antenna coil. Allow the primer to dry
for 5 minutes before proceeding with the next step.
2
Remove backing from one side of supplied two-way tape
( E ) and apply tape around transceiver antenna coil.
3
D
E
A
B
C
D
E
SECURILOCK KIT
COMPONENTS