Filter
Top Products
Roadside
emergencies
172
4. Remove the center cap or wheel
cover. Loosen each wheel lug nut
oneĆhalf turn counterclockwise but
do not remove them until the wheel
is raised off the ground.
5. The vehicle jacking points are
depicted on the yellow warning
label on the jack shown here.
Locate the jack at the half moon
cutout located
- approximately 15 cm (6 inches)
from the front wheel opening
(1).
- approximately 38 cm (15 inches)
from the rear wheel opening (2).
Jack at the specified locations
to avoid damage to the vehicle.
Turn the jack handle
counterclockwise to lower the jack
until it can be inserted under the
vehicle at the jacking point.
Turn the jack handle clockwise to
raise the jack. While raising the
jack, be sure the body flange
engages the slot on top of jack as
shown.
Turn the jack handle clockwise
until the wheel is completely off the
ground.