Filter
Top Products
Assembly
• Flatten the "T" end of one of the seat belts.
• Insert the "T" end of the seat belt through one of the
slots in the seat.
• Pull up on the seat belt to be sure it is secure.
• Repeat this procedure to assemble the other seat belt
to the seat.
• With the flag pointing toward the front of
the seat, insert the flag pole down
through the hole in the top of the seat.
• Turn the flag pole so that the flag is
toward the back of the seat.
• Insert two #8 x
3
/
4
" screws through the
flag pole and into the back of the seat
as shown. Tighten the screws with a
Phillips screwdriver. Do not over-tighten.
11
9
10
• Fit the action sounds box to the action sounds box
cover .
• Wrap the cover flaps around the action sounds box, as
shown .
7
• Insert the bottom tabs on the action sounds box into the
slots in the inside of the front end of the vehicle .
• Push the action sounds box to "snap" the action sounds
box into place .
Hint: To remove the action sounds box when replacing
batteries, insert a slotted screwdriver into the slot at the
top of the action sounds box. Pull to remove the action
sounds box.
8
Action Sounds
Box Cover
Action Sounds Box
Action Sounds Box
Tabs
Seat
Flag Pole
Slot
“T” End
Seat Belt
B
A
B
Wrap
Flap
Wrap
Flap
A
B
Slots
A
B
A
B
Tabs
Slots
76790pr-0920 5/1/02 8:30 AM Page 11