Filter
Top Products
Battery Installation
IMPORTANT! Use only a Power Wheels
®
Type H 6 volt
battery with a Power Wheels
®
25 Amp fuse installed. Use
of any other battery or fuse will damage your vehicle. Make
sure that you charge the battery for at least 18 hours using
the enclosed Power Wheels
®
6 volt charger before oper-
ating your vehicle for the first time. Charge the battery for
at least 14 hours after each use of the vehicle. Never
charge the battery longer than 30 hours. Failure to follow
these instructions may damage your battery and will void
your warranty.
• Place a Power Wheels
®
6 volt battery upright in the
battery compartment, as shown.
• Loosen the screw in the rear bumper cover (battery
clamp), as shown
• Remove the rear bumper cover (battery clamp).
15
1
2
H
• Plug the battery connector into the motor harness
connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again. Do not force
the battery connector into the motor harness connector.
3
Bumper Cover
(Battery Clamp)
• Replace the rear bumper cover (battery clamp).
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten
4
Motor Harness
Connector
Battery Connector
76790pr-0920 5/1/02 8:30 AM Page 15