Fisher-Price 76790 Motorized Toy Car User Manual


 
Battery Charging
Loosen the screw in the rear bumper cover
(battery clamp).
Remove the rear bumper cover.
Lift to remove the battery from the battery compartment.
Plug the battery connector into the charger connector.
IMPORTANT! The battery must be removed from your vehicle for the initial charge in order to complete assembly.
After assembly is complete, you do not need to remove the battery from your vehicle to recharge it.
Insert a Power Wheels
®
25 amp fuse into the battery.
Note: The top of the fuse will not be flush with the top of
the battery when properly installed.
2
1
3
4
8
Plug the charger into a standard 120 volt wall outlet.
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is ON.
Before first time use, charge the battery for at least 18
hours. Never charge the battery longer than 30 hours.
Note: The battery must be upright while charging.
Recharge the battery after each use of your vehicle for
at least 14 hours. Do not charge the battery longer than
30 hours.
Once the battery is charged, disconnect the charger
connector from the battery connector. Unplug the charger
from the wall outlet. The battery is now ready to be
installed in your vehicle. Please see “Battery Installation”
on page 15 for detailed instructions on installing your
battery. If your battery is already installed in your vehicle,
simply re-connect the battery connector and motor
harness connector and replace the bumper cover
(battery clamp).
Battery
Connector
Charger
Connector
25 Amp Fuse
5
Bumper Cover
(Battery Clamp)
6 Volt Battery
76790pr-0920 5/1/02 8:30 AM Page 8