Filter
Top Products
Page 10
Press “Up” or “Down” to select another function or “Mode” to
return to “Normal” mode.
Speedometer Calibration
1
Speedometer
Calibration2
3
Press and hold the “Up” and “Down” for 2 seconds to select
“Speedometer Calibration.”
Press “Up” or “Down” to select another function or “Mode” to
return to “Normal” mode.
NOTE: To calibrate the speedometer another “reference” must
be available. This can be the GPS speed (SOG), a radar gun,
or some other source of accurate speed indication. Maintain
a constant speed and heading to allow the reference and the
speedometer to stabilize before attempting to calibrate the
speedometer. Calibration accuracy is best if the speedometer is
calibrated at mid-range on the dial.
Press the “Up” or “Down” button while observing speedometer
pointer. When speedometer pointer indicates the same speed
as the reference, press and hold “Up” and “Down” for 2 seconds
to save the calibration and return to “Edit” mode.
1
Calibrate
Speedometer2
3
Press “Up” or “Down” to select another function or “Mode” to
return to “Normal” mode.
Select Speedometer Signal
1
Select
Speedometer
Signal
2
3
NOTE: This function is normally only used by OEMs and
dealers. Do not change this selection without ensuring that the
correct selection is being made. Consult your dealer before
changing this selection. This signal may come from the bus in
which case that signal is used in lieu of these inputs.
Press and hold the “Up” and “Down” for 2 seconds to select
“Speedometer Signal.”
Press “Up” or “Down” to select another function or “Mode” to
return to “Normal” mode.
Press the “Up” or “Down” button to scroll through the
selections. When correct choice is next to the selection arrow,
press and hold “Up” and “Down” for 2 seconds to save the
selection and return to “Edit” mode.
1
> Pitot Tube
Paddle wheel2
3
Press “Up” or “Down” to select another function or “Mode” to
return to “Normal” mode.
NOTE: IF PITOT IS SELECTED WITH NO PITOT SIGNAL
AVAILABLE, THE SPEEDO WILL SHOW MAXIMUM SPEED AT
ALL TIMES.