Filter
Top Products
Page 8
Edit Mode
The “Edit” mode is used to adjust or set the values of functions and options in the
MG2000 Speedometer. The procedure below specifies the steps to be taken in the
“Edit” mode to adjust / set each option.
To enter “Edit” mode, press “Mode” and “Up” button while in “Normal” mode
To return to “Normal” mode, press “Mode” button once while in “Edit” mode
Functions that are set or adjusted in the “Edit” mode
1. Select Default Screen
2. Reset Trip Log
3. Organize User Screens
4. Speedometer Calibration
5. Select Speedometer Signal
6. Adjust Clock Offset
7. Set Clock Type
8. Adjust COG Type
9. Select Self Test
10. Software Id and Revision
Instructions – Function
Line Display
Select Default Screen
1 Select
Default
Screen
2
3
Press and hold the “Up” and “Down” for 2 seconds to select the
“Default Screen.”
Press “Up” or “Down” to select another function or “Mode” to
return to “Normal” mode.
(Display Screen 1 is the “Default” at first turn on.)
1
Default
Display
Screen 1
2
3
Press and hold the “Up” and “Down” for 2 seconds to select
screen 1 as the “Default Screen” and exit.
Press “Up” or “Down” to select another screen.
1 Default
Display
Screen 2
2
3
Press and hold the “Up” and “Down” for 2 seconds to select this
screen as the “Default Screen” and exit.
Press “Up” or “Down” to select another screen
Repeat until desired “Default screen” is selected.
1
Default
2 Display
3
Screen
Press “Up” or “Down” to select another function or “Mode” to
return to “Normal” mode.
Reset Trip Log
1 Reset
Trip
Log
2
3