Filter
Top Products
Maintenance
close together as possible without touching
(approximately .06 inch (1.5 mm) gap is desirable).
The switch mounting plate can be moved up or
down to adjust the position of the lower neutral
switch.
8. Check the function of the neutral switches by
temporarily replacing the key. With the engine
off, turn the ignition switch to the “ON” position.
Locate the LCD indicator in the message display.
Raise and lower the deck.
A. If the indicator displays while moving the deck
up and down, the neutral switches have been
adjusted properly and no further adjustment
is necessary.
B. If the indicator does not stay lit while moving
the deck up and down, contact an Authorized
Service Dealer. Remove the key.
Adjust RH Motion Control
Handle Position
If the motion control levers do not align horizontally,
adjust the right side motion control lever.
Note: Adjust the horizontal alignment before the
front to back alignment.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Push the right motion control lever down out of
locked neutral position.
3. Check if it aligns horizontally with the left motion
control lever.
Figure 35
1. LH Motion control lever
2. RH Motion control lever
3. RH Motion control lever in PTO disengaged position
4. Check the horizontal alignment here
4. To adjust the right motion control lever
horizontally, the cam needs to be adjusted.
5. Release the cushion from the rear of the machine.
6. Loosen the nut and bolt holding the cam.
7. Adjust the cam until it aligns with the left motion
control lever and tighten the nut and bolt for the
cam.
Figure 36
1. Switch screws
2. Nut and bolt
3. Cam
4. Front reference/speed control handle
8. After the cam is adjusted, the lever switch needs
to be checked.
9. Check the gap between the control lever and
switch as shown in Figure 37. The gap needs
to be an 1/8 inch (3mm) with the right motion
control lever in the neutral, operate position.
41