Filter
Top Products
Operation
Adjusting the Cutting Height
The cutting height of the mower deck is adjusted
from 1 to 5 inches (2.5 cm to 12.7 cm) in 1/4 inch
(6.4 mm) increments.
1. Stop the machine and move the motion control
levers to the neutral position.
2. Disengage the PTO.
3. Raise and lock the deck to the 5 inch (12.7 cm)
transport position.
The deck is raised by pulling the deck lift handle
rearward and to the right to place it into the
transport lock position.
Figure 14
1. Transport lock position
3. Front reference/speed
control bar
2. RH Motion control lever
4. Deck lift handle
Note: When changing the cutting height
positions, always come to a complete stop
and disengage the PTO.
4. Insert the height adjustment pin into the hole
corresponding to the desired cutting height.
See the decal on the side of the deck lift plate for
cut heights (reference Figure 15).
5. Pull the deck lift handle rearward and to the left
and slowly allow the deck to lower to the cutting
height.
Figure 15
1. Height adjustment pin
3. Deck lift handle
2. Height of cut holes
Transporting
Transporting a Unit
Use a heavy-duty trailer or truck to transport the
machine. Lock brake and block wheels. Securely
fasten the machine to the trailer or truck with straps,
chains, cable, or ropes. Be sure that the trailer or truck
has all necessary lighting and marking as required by
law. Secure a trailer with a safety chain.
CAUTION
This unit does not have proper turn
signals, lights, reective markings, or a
slow moving vehicle emblem. Driving on a
street or roadway without such equipment
is dangerous and can lead to accidents
causing personal injury. Driving on a street
or roadway without such equipment may also
be a violation of State laws and the operator
may be subject to trafc tickets and/or nes.
Do Not drive a unit on a public street or
roadway.
23