Filter
Top Products
6
©
2005
Directed Electronics, Inc. all rights reserved
H1/3 WHITE/BLUE 200 mA (-) channel 3 output
This wire provides a (-) 200 mA output whenever the transmitter button(s) controlling channel
three is pressed. This output can be programmed to provide the following types of output (see
System Features Learn Routine
section of this guide):
➤➤
A
vvaalliiddiittyy
output will send a signal as long as the transmission is received.
➤➤
A
llaattcchheedd
output will send a signal continuously when the channel three button(s) is pressed and
released. The signal will continue until channel three is pressed again.
➤➤
A
llaattcchheedd//rreesseett wwiitthh iiggnniittiioonn
output works similar to the latched output, but will also reset
(output will stop) when the ignition is turned on and then off.
➤➤
A
3300 sseeccoonndd ttiimmeedd
output will send a signal for 30 seconds when channel three is pressed. This
output can be shut off during the 30-second period by pressing Channel 3 again.
➤➤
This output can also be programmed to provide a
sseeccoonndd uunnlloocckk ppuullssee
when the unlock button
is pressed a second time after disarming the system. This can be used to unlock the passenger
doors when installing progressive door locks.
H1/4 BLACK/WHITE (-) 200 mA domelight supervision output
Connect the H1/4 wire to the optional domelight supervision relay as shown in the following
diagram:
IMPORTANT! This output is only intended to drive a relay. It cannot be connected
directly to the domelight circuit, as the output cannot support the current draw of one
or more bulbs.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input!
This transistorized output can only supply 200 mA, and connecting directly to a
solenoid, motor, or other high-current device will cause the module to fail.