Filter
Top Products
12
©
2005
Directed Electronics, Inc. all rights reserved
3. Mount the receiver/antenna using the supplied double-sided tape.
4. Route the receiver/antenna cable to the control module and plug it into the four-pin antenna
connector.
On-Board Dual-Stage Shock Sensor
There is a dual-stage shock sensor inside the control unit. Adjustments are made via the rotary
control as indicated in the diagram. Since the shock sensor does not work well when mounted
firmly to metal, we do not recommend screwing down the control module. The full trigger of the
on-board shock sensor reports Zone 2. (See
Table of Zones
section of this guide.)
Note: When adjusting the sensor, it must be in the same mounting location that it will be after the
installation is completed. Adjusting the sensor and then relocating the module requires
readjustment.
IMPORTANT! To achieve the best possible range, DO NOT leave the antenna cable
bundled under the dash. Always extend the cable full length during installation,
regardless of the antenna mounting location.