Filter
Top Products
©
2005
Directed Electronics, Inc. all rights reserved
27
within a one hour period. For a full description of NPC operations refer to the owner's manual.
Rapid Resume Logic
Rapid Resume Logic ensures that the when the system is powered up it will return to the same state
it was in when power is disconnected. For a full description of Rapid Resume Logic refer to the
owner's manual.
Troubleshooting
Starter kill doesn’t work.
➤
Is the correct starter wire being interrupted? If the car starts when the starter kill relay is
completely disconnected, the wrong starter wire has been cut and interrupted.
➤
YELLOW wire is not connected to true ignition. It is connected to an accessory circuit.
Shock sensor doesn’t trigger the alarm.
➤
Has the NPC
®®
system been triggered? If so, you will hear five chirps when disarming. To check
this, turn the ignition key on and off to clear the NPC
®®
from memory, and then retest the
shock sensor. For a detailed description of NPC
®®
, see Owner’s Guide.
Door input does not immediately trigger full alarm. Instead, I hear chirps for the first three seconds.
➤
That’s how the progressive two-stage door input works! This is the instant response feature of
this system. Even if the door is closed immediately, the system provides an instant trigger by
chirping, and the progressing to a constant siren.
Closing the door triggers the system, but opening the door does not.
➤
Have you correctly identified the type of door switch system? This happens often when the
wrong door input has been used.
System will not passively arm until it is remotely armed and then disarmed.
➤
Are the door inputs connected? Is a blue wire connected to the door trigger wire in the vehicle?
Either the green H1/5 or the violet H1/7 should be used instead.
IMPORTANT: When testing the systems sensor and trigger inputs reset NPC by
turning on the ignition after every third system trigger.