Filter
Top Products
17
Step 1. Secure ball coupler to 2" (5,000 lb. capacity) towing
vehicle ball only. Make sure that the hitch and the hitch ball
are in good condition and not rusted, loose or stripped.
Recommended ball height is 18" to the top of the ball.
Make sure hitch is locked down and secured with safety clip.
Criss-cross safety chains under tongue and secure to towing
vehicle frame.
LOADING INSTRUCTIONS
.
Step 3. Loosen wing nut on back of license plate holder, turn
the clip on the front to a horizontal position and put license in the
"down" position. Turn the clip back so it rests against the back
of the light bar to hold the license down and tighten wing nut.
(License must be "UP" with the tow dolly empty).
Step 2. Remove black locking pin BEFORE loading vehicle
onto the Kar Kaddy. The removal of the locking pin allows
"Auto Steer" to operate. When towing the dolly empty, this pin
must be in place.
IMPORTANT: Over all width of towed vehicle must not
exceed:
76" max. (outside to outside),
42" min. (inside to inside),
78" max. (body width).
Step 4. Before loading (and unloading) towed vehicle make
sure platform and towed vehicle are in straight alignment.
Tow dolly must be completely and properly hooked up to the
towing vehicle. Towing vehicle must be larger and at least
1000 lbs. heavier than the tow dolly and towed vehicle
combined.