Filter
Top Products
15
1. Pull ramp back as far as it will go. Bolt must be past
notch before attempting the next step.
2. Lift ramp until it is past center and resting on it stops.
Folding Ramp
IMPORTANT:
When taking this tow dolly out of storage it is very impor-
tant to check all pins and retainers for damage. If damage is found
replace. Do not use damaged pins or retainers. Make sure that
tongue pin and retainer clip is replaced after tongue is folded back
to the forward and locked position. Fold ramps down as far as they
will go and push forward until you hear or see retainer handles
snap into their locked positions. Check to make sure they all fully
seated. Make sure that all pins and locking devices are double
checked before returning this unit to service.
NOTE:
Tow Dolly must be empty and unhooked
to perform any and all of these steps. Do
not attempt while tow dolly is loaded or
hooked up.
Loading Angle Clearance Guide
IMPORTANT:
Using this guideline will reduce the chance of the towed
vehicles air dam, or bottom of facia from interfering with
tow dolly platform and or tire stop. “X” must be less
than 3-1/2 x “Y”.
Example: If Y measures 6”
3-1/2 x 6 = 21
X must measure less than 21”
NOTE: User’s responsibility for checking clearance