Filter
Top Products
mAI085-MB Actuator Interface Technical Manual /17
Distributive Intelligence
CMC INDUSTRIAL ELECTRONICS LTD
Display
Function Response
second YES response starts the operation. The upper display indicates
the controller address and the lower display the result of the query. All
addresses marked active are queried. Once complete, the lower display
shows DonE. Should an active actuator controller not be found, the
lower display will show FAiL. Each active address is tried 5 times. If you
are uncertain that a controller’s parameters have been retreived, use the
GEt function within the “Configure Actuator Controllers Menu” to verify
the operation.
Snd
Send the operational parameters to all active controllers on the network.
A YES response displays SUrE in the lower display. The second YES
response starts the operation. The upper display indicates the controller
address and the lower display the result of the query. All addresses
marked active are queried. Once complete, the lower display shows
DonE. Should an active actuator controller not be found, the lower
display will show FAiL. Each address is tried 5 times. If you are
uncertain that a controller’s parameters have been sent, use the Snd
function within the “Configure Actuator Controllers” Menu to verify the
operation.
***************************** WARNING ********************************
This function will overwrite all of the actuator controllers locally
saved parameters. This may cause unpredictable results in these
field devices. Verify the parameters in the mAI085-MB are correct
before executing this function.
dnL
Download the sensor data table to a PC. See Appendix A – Editing
Sensor data tables on a PC.
YES/no
UPL
Upload the sensor data table from a PC. See Appendix A – Editing
Sensor data tables on a PC.
YES/no
dGn
Go to the Modbus Slave Interface Menu.
YES/no