Filter
Top Products
Black plate (6,1)
Chevrolet Corvette Owner Manual - 2011
2-6 Keys, Doors and Windows
9. To program additional
transmitters, repeat Step 7.
Press Acc. on the ignition switch
if programming is complete.
10. Press
K on each newly
programmed transmitter to
complete the process.
Programming without a
Recognized Transmitter
This procedure requires three
ten minute cycles to complete
the programming process.
United States owners are permitted
to program a new transmitter to
their vehicle when a recognized
transmitter is not available.
The Canadian immobilizer standard
requires that Canadian owners see
their dealer for programming new
transmitters when two recognized
transmitters are not available.
1. The vehicle must be off.
2. Place the new transmitter in the
glove box transmitter pocket
with the buttons facing the
passenger side.
3. Insert the vehicle key into the
key cylinder located above the
license plate.
4. Open the hatch/trunk.
5. Turn the key five times within
five seconds.
6. The DIC message displays
OFF-ACCESSORY TO LEARN.
7. Press Acc. on the ignition
switch.
8. The DIC reads WAIT
10 MINUTES and counts
down to zero.
9. The DIC displays
OFF-ACCESSORY TO
LEARN again.
10. Press Acc. on the ignition
switch.
11. Steps8, 9 and 10 will be
repeated two more times.
12. A beep sounds and the DIC
reads READY FOR FOB #1.
All previously known
transmitter programming
has been erased.