Filter
Top Products
Black plate (69,1)
Chevrolet Corvette Owner Manual - 2011
Instruments and Controls 5-69
.
If you wrote “Right,” press
the right button in the
vehicle.
.
If you wrote “Middle,” press
the middle button in the
vehicle.
6. After entering all of the switch
positions, again, firmly press and
release all three buttons at the
same time. The indicator lights
turn on.
7. Press and hold the button
that will be used to control the
garage door until the garage
door moves. The indicator
light above the selected button
should slowly blink. This button
may need to be held for up to
55 seconds.
8. Immediately release the button
when the garage door moves.
The indicator light blinks rapidly
until programming is complete.
9. Press and release the same
button again. The garage door
should move, confirming that
programming is successful and
complete.
To program another Fixed Code
device such as an additional garage
door opener, a security device,
or home automation device, repeat
Steps 1-9, choosing a different
button in Step 7 than what was
used for the garage door opener.
Universal Remote System
Operation
Press and hold the appropriate
button for at least half of a second.
The indicator light comes on while
the signal is being transmitted.
Operation can occur:
.
If the vehicle is in
accessory mode.
.
If the vehicle is in running.
.
If the vehicle is in Retained
Accessory Mode (RAP).
See Retained Accessory
Power (RAP) on page 9‑21 for
more information.
.
Up to an additional 10 minutes
after RAP finishes.
.
Up to 10 minutes after any door
is opened.