Filter
Top Products
Black plate (7,1)
Chevrolet Corvette Owner Manual - 2011
Infotainment System 7-7
Finding a Station
BAND: Press to switch between
FM1, FM2, AM, XM1 or XM2.
O e (Tune): Turn to select radio
stations.
t SEEK u : Press to go to the
previous or to the next station and
stay there.
The radio only stops at stations with
a strong signal.
t SCAN u : Press and hold
t or u for 2 seconds until
FREQUENCY SCAN displays.
The radio goes to a station, plays
for a few seconds, then goes on
to the next station. Press
t or u
again to stop scanning.
To scan preset stations:
Press and hold
t or u for
four seconds until PRESET
SCAN displays. The radio goes to
the next preset station, plays for a
few seconds, then goes to the next
preset station. Press
t or u again
or one of the pushbuttons to stop
scanning presets.
The radio only scans stations with a
strong signal.
1–6 (Preset Pushbuttons):
Press to play stations that are
programmed to the radio preset
pushbuttons.
Storing Radio Stations
Drivers are encouraged to store
radio station while the vehicle is
parked, see Defensive Driving on
page 9‑2. Tune to stored radio
stations using the presets, favorites
button, and steering wheel controls,
if the vehicle has this feature.
Up to 30 stations (6 FM1, 6 FM2,
and 6 AM, 6 XM1 and 6 XM2),
and equalization settings for each
station can be programmed on the
six numbered pushbuttons.
To set presets:
1. Tune to a radio station.
2. Press AUTO EQ to select the
equalization.
3. Press and hold one of the six
numbered pushbuttons until the
radio beeps once.
4. Repeat the steps for each
pushbutton.