Filter
Top Products
7. Press Acc. on the ignition switch.
8. The DIC reads WAIT 10 MINUTES and counts
down to zero.
9. The DIC displays OFF-ACCESSORY TO LEARN
again.
10. Press Acc. on the ignition switch.
11. Steps 8, 9 and 10 will be repeated two more times.
12. A beep sounds and the DIC reads READY FOR
FOB #1. All previously known transmitter
programming has been erased.
13. A beep sounds once programming in complete.
The DIC displays READY FOR FOB #2.
To program additional transmitters, take transmitter 1
out of the transmitter pocket and place transmitter 2
in the pocket. Up to four transmitters can be
programmed. The DIC then displays MAXIMUM
NUMBER OF FOBS LEARNED and exits the
programming mode.
Press Acc. on the ignition switch to complete the
process.
14. Press Acc. on the ignition switch if programming is
complete.
15. Press
K on each newly programmed transmitter to
complete the process.
Starting the Vehicle with a Low
Transmitter Battery
If the transmitter battery is weak, the DIC may display
NO FOBS DETECTED when trying to start the vehicle.
To start the vehicle, place the transmitter in the glove
box transmitter pocket with the buttons facing the
passenger side. Then, with the vehicle in P (Park)
for an automatic transmission, press the brake pedal
and
/ . If the vehicle has a manual transmission, press
the clutch and
/ . Replace the transmitter battery as
soon as possible. Change the transmitter battery if
the DIC displays FOB BATTERY LOW.
2-9