Filter
Top Products
To scan preset stations:
Press and hold
t or u for four seconds until PRESET
SCAN displays. The radio goes to the next preset station,
plays for a few seconds, then goes to the next preset
station. Press
t or u again or one of the pushbuttons
to stop scanning presets.
The radio only scans stations with a strong signal.
1-6 (Preset Pushbuttons): Press to play stations that
are programmed to the radio preset pushbuttons.
Setting Preset Stations
Up to 30 stations (six FM1, six FM2, and six AM,
six XM1 and six XM2), and equalization settings for
each station can be programmed on the six numbered
pushbuttons.
To set presets:
1. Turn the radio on.
2. Press BAND to select FM1, FM2, AM, or XM1
or XM2.
3. Tune in the desired station.
4. Press AUTO EQ to select the equalization.
5. Press and hold one of the six numbered
pushbuttons until the radio beeps once.
6. Repeat the steps for each pushbutton.
Finding a Category (CAT) Station
(XM Satellite Radio Service Only)
To select an XM station by category:
1. Press CAT. The last selected category displays.
2. Turn the
O e knob to select a category.
3. Press
t or u to go to a category’s station.
SEEKING CATEGORY displays.
4. To go to another station within that category,
press the CAT button to display the category,
then press t or u to go to another station.
If the radio cannot find the desired category, NONE
displays and the radio returns to the last station tuned.
SCAN: To scan the stations within a category:
1. Press CAT. The last selected category displays.
2. Turn the
O e knob to select a category.
3. Press and hold
t or u until a beep sounds and
SCAN CATEGORY displays. The radio begins
scanning the stations in the category.
4. Press
t or u to stop scanning.
3-87