Filter
Top Products
Pre-Operation Check
ƽ
WARNING
The pre-operation check is very
important prior to operating the
vehicle. Always check the prop-
er operation of critical controls,
safety features and mechanical
components before starting. If
not done, severe injury or death
might occur.
Before using this vehicle, the operator
should always:
• Apply parking brake and check if it
operates properly.
• Check tire pressure and condition.
• Check wheels and bearings for
wear and damage.
• Check location of controls and en-
sure they work properly.
• Verify if steering operates freely.
• Activate throttle control lever sever-
al times to ensure it operates freely.
It must return to idle position when
released.
• Activate the brake lever and brake
pedal to make sure the brakes fully
apply. They must fully return when
released.
• Check all brake line fittings for tight-
ness and against leaks.
• Whit parking brake correctly ap-
plied, activate the clutch lever. It
must fully return when released.
• Check drive chain for adjustment
and lubrication.
• Check sprockets for wear and dam-
ages.
• Check tightening of rear axle fasten-
ers.
• Check swing arm, if any lateral play
is detected
DONOTUSETHEVE-
HICLE
.
• Check fuel, oil and coolant levels.
• Check for oil leaks on the engine, oil
tank and transmission.
• Ensure fuel valve is in fully open
position (ON).
• Clean headlamp and taillight.
• Ensure seat is properly latched.
• If you transport cargo, respect load
capacity. Ensure cargo is properly
secured to the vehicle.
• Look and feel for loose parts while
engine is off. Check fasteners.
• Ensure the path of travel is free of
persons and obstacles.
• Check operation of ignition switch,
start button, engine stop switch
and headlamp switch.
• Start engine, remove parking brake
and drive forward slowly a few feet
then apply all brakes individually to
test them.
Correct any problem you may have
found before riding. See an autho-
rized Bombardier ATV dealer as nec-
essary.
40
___________
SAFETY INFORMATION
___________