Filter
Top Products
Spark Arrester
The muffler must be periodically
purged of accumulated carbon. See
the MAINTENANCE CHART.
Removal
ƽ
WARNING
Never run engine in an enclosed
area. Never perform this opera-
tion immediately after the engine
has been run because exhaust sys-
tem is very hot. Make sure that
there are no combustible materi-
als in the area. Wear eye protec-
tion and gloves. Never stand be-
hind the vehicle while purging ex-
haust system. Respect all applica-
ble laws and regulations.
Remove:
– the screws retaining the spark ar-
rester to the muffler
V02C06Y
1
2
1
1. Screws
2. Spark arrester
– spark arrester and sealant joint
V02C07Y
1
2
3
1. Spark arrester
2. Sealant joint
3. Muffler
– inner grill with wool.
Remove all carbon deposit in the muf-
fler.
Remove carbon deposits from the
spark arrester using a brush.
NOTE:
Use a soft brush and be careful
to avoid damaging spark arrester.
Installation
For installation, reverse the removal
procedure, pay attention to the follow-
ing details:
Check:
– insulated wool and change if it is
deteriorated
– the spark arrester condition, it must
be free of breaks and holes. Re-
place if necessary.
Remove the old sealant joint and re-
place by a new one. Use ULTRA
COOPER sealant (P/N 293 800 090) or
an equivalent product.
_____________________
99