Filter
Top Products
Black plate (6,1)
Cadillac CTS/CTS-V Owner Manual - 2011
2-6 Keys, Doors and Windows
Press and hold L for more than
two seconds to activate the panic
alarm. The turn signal lamps
flash and the horn sounds for
30 seconds. The alarm turns off
when the ignition is moved to
START or
L is pressed again. The
ignition must be in LOCK/OFF for
the panic alarm to work.
The vehicle comes with
two transmitters. Each transmitter
will have a number on top
of it, “1” or “2”. These numbers
correspond to the driver of the
vehicle. For example, the memory
seat position for driver 1 will be
recalled when using the transmitter
labeled “1”, if enabled through the
DIC. See “Memory Seat” under
Power Seat Adjustment on page 3‑5
and Vehicle Personalization on
page 5‑46 for more information.
Programming Transmitters to
the Vehicle
Only RKE transmitters programmed
to the vehicle will work. If a
transmitter is lost or stolen, a
replacement can be purchased and
programmed through your dealer.
When the replacement transmitter
is programmed to the vehicle, all
remaining transmitters must also
be programmed. Any lost or stolen
transmitters no longer work once the
new transmitter is programmed.
Each vehicle can have up to
eight transmitters programmed to it.
Battery Replacement
Replace the battery if the Replace
Battery In Remote Key message
displays in the DIC. See “Replace
Battery In Remote Key” under Key
and Lock Messages on page 5‑37
for additional information.
Notice: When replacing the
battery, do not touch any of the
circuitry on the transmitter. Static
from your body could damage the
transmitter.
To replace the battery:
1. Separate the transmitter with
a flat, thin object inserted into
the notch, located above the
metal base.
2. Remove the old battery. Do not
use a metal object.