Cadillac 2010 CTS Sport Wagon Automobile User Manual


 
8-42 Driving and Operating
CTS Shown, CTS-V Similar
The cruise control buttons are
located on the left side of the
steering wheel.
I (On/Off): Press to turn the
system on or off. The indicator light
on the button turns on when cruise
control is on.
+ RES (Resume/Accelerate):
Press to make the vehicle
accelerate or resume to a previously
set speed.
SET (Set/Coast): Press to set
the speed or make the vehicle
decelerate.
[ (Cancel): Press to cancel cruise
control without erasing the set
speed from memory.
Setting Cruise Control
Cruise control will not work if the
parking brake is set, or if the master
cylinder brake fluid level is low.
The cruise control light on the
instrument panel cluster comes on
after the cruise control has been set
to the desired speed.
{
WARNING
If you leave your cruise control on
when you are not using cruise,
you might hit a button and go into
cruise when you do not want to.
(Continued)
WARNING (Continued)
You could be startled and even
lose control. Keep the cruise
control switch off until you want to
use cruise control.
1. Press the
I button.
2. Get up to the desired speed.
3. Press the SET button located
on the steering wheel and
release it.
4. Take your foot off the
accelerator.
Resuming a Set Speed
Suppose the cruise control is set at
a desired speed and then the brake
is applied. This shuts off the cruise
control. But it does not need to be
reset.
Once the vehicle is driving at about
40 km/h (25 mph) or more, press the
+RES button on the steering wheel.