Bulldog Security INSTALLATION GUIDE OWNER'S GUIDE Automobile Alarm User Manual


 
4 25
SYSTEM FEATURES
Four-Button Remotely start your car to run the heater or air
Extended Range conditioning from an extended distance.
Remote Control
Keyless Entry Remotely locks and unlocks your power door locks.
Trunk Release Remotely opens your trunk with a push of a
button. (Optional part #775 required)
Remote Programmable Remotely program your vehicle to run 5 to 15
Run Time minutes.
Run Time Lets you check the run time that the unit is
Confirmation programmed for.
Tach/Tachless A programmable feature that lets you choose from the
Option easy to install tachless operation or the standard
wire-in, tach operation.
Parking Light Confirms that your vehicle has received a remote
Confirmation signal and will remain on if the engine is remotely
started.
Dome Light Never walk up to a dark vehicle again. When unlocking
Supervision the vehicles doors by remote control the dome light will
come on and stay on for 1 minute, or until you activate the ignition
switch. (Optional part #775 required)
Cold Start Remotely program your car to start at a preset
temperature. Automatically starts your car in freezing
temperature so you never have a dead battery.
Pit Stop Mode Allows you to exit the vehicle while the engine
remains running.
Extended Range Allows you to operate your system from up to 400 feet
Antenna away. (800 feet for E Models)
Code Learning Allows your remote starter to learn new remotes,
should you want to add remotes, or if remotes are lost.
Limited Lifetime Guarantees life-long protection.
Warranty
ATTENTION:
We urge you to immediately place this card in your wallet.
OPERATING FUNCTIONS
FOR YOUR WALLET OR GLOVE BOX
1-800-878-8007
www.jbstech.com
MADE IN AMERICA, GUARANTEED FOREVER
Starting with the Remote Transmitter Press and release button #1. The parking lights
will flash once, confirming the car starter received the signal. The car will then start
and the parking lights will remain on while the vehicle is running. To shut off the
engine before the preset time, press button #4 or press the brake pedal. NOTE: If your
car does not start on the first crank it will automatically attempt to start 2 more
times (in tachless mode). While in tachless mode, parking lights will wait approximately
10 seconds before turning on. Pit Stop: Exiting the Car with the Engine Running Make
sure the transmission is in park and press button #1 before turning the ignition switch
off. Keyless Entry Operation Press button #2, the parking lights will flash once and
the doors will lock. Press button #2 again, the parking lights will flash twice, the
doors will unlock, and the parking lights will remain on for one minute or until you
turn the ignition on or press the brake. Dome Light Option (optional) The dome light
will remain on for one minute or until you turn the ignition on or press the brake.
Trunk Release Output Optional output modules are available to do one of the following:
open the trunk, roll up the windows, close the sun roof etc. This output will pulse
.75 seconds when pressed and released. In instances where a continuous signal is needed
such as sun roof and power windows, hold down button #3 as long as the signal is needed.
The parking lights will remain on as long as this button is being pressed.
Runtime
Confirmation Press and release Button #4. The parking lights will begin to flash. Each flash equals
5 mnutes of runtime.