Filter
Top Products
12 17
MECHANICAL NEUTRAL SAFETY SWITCH (Rear Wheel Drive Only)
When installing a Bulldog remote starter on GM vehicles or Dodge
Dakotas built prior to 1996, you must:
Use the diagram below to create a circuit that will prevent the
remote starter from starting the vehicle unless the key is removed
from the ignition switch.
PRE-1996 GM REAR WHEEL DRIVES WITH PURPLE CRANK WIRE
Optional part #775 required.
NEUTRAL SAFETY SWITCH OPTIONAL CONNECTIONS
DOME LIGHT (-) (Optional Part #775 required)
To determine if your dome light is turned on with (+) positive or (-
) negative trigger, probe for a wire in the driver’s side kick panel
that switches polarity when the door is closed then opened. You can
also find this wire going to the under dash courtesy lights.
•If this wire reads +12V when the door is open and (-)
ground when the door is closed, it is (+) positive. (most
Fords)
•If this wire reads (-) ground when the door is open
and +12V when the door is closed, it is (-) negative.
“Type C” (continued)
Ground
Ground
DO NOT USE RED WIRE, TAPE OFF
PRE-1996 DODGE DAKOTAS
Optional part #775 required.
86
30
87a
87
85
5 Amp
fuse
Tie into heavy
white wire on
4-relay harness
(-) Negative
hood pin wire
Message center
or key buzzer
Driver’s Door Switch
Key
Cylinder
BLACK/LT.BLUE
LT.BLUE/GREEN
BLACK
YELLOW
BLUE
WHITE
RED
Not Used
FUSE
Ground
Ground
86
30
87a
87
85
5 Amp
fuse
Tie into heavy
white wire on
4-relay harness
(-) Negative
hood pin wire
Message center
or key buzzer
Driver’s Door Switch
Key
Cylinder
TAN
GREEN
BLACK
YELLOW
BLUE
WHITE
DO NOT USE RED WIRE, TAPE OFF
RED
Not Used
FUSE