Filter
Top Products
33
The connections to the battery’s positive and negative terminals are incorrect. Follow the steps outlined in
“Important Safety Instructions” at the front of this manual to disconnect AC cord and clamps and reconnect to
battery with correct polarity.
F
F
0
0
7
7
—
—
A
A
l
l
t
t
e
e
r
r
n
n
a
a
t
t
o
o
r
r
V
V
o
o
l
l
t
t
a
a
g
g
e
e
Alternator output voltage is out of typical operation range.
C
C
h
h
a
a
r
r
g
g
i
i
n
n
g
g
a
a
V
V
e
e
r
r
y
y
C
C
o
o
l
l
d
d
B
B
a
a
t
t
t
t
e
e
r
r
y
y
If the battery to be charged is very cold (in temperatures below freezing — 0°C/ 32°F), it cannot accept a high
rate of charge. The initial charge rate will be low. The charge rate will increase as the battery warms. Never
attempt to charge a frozen battery.
CARE AND MAINTENANCE
With proper care and minimal maintenance, the
3
3
0
0
A
A
m
m
p
p
S
S
m
m
a
a
r
r
t
t
™
™
B
B
a
a
t
t
t
t
e
e
r
r
y
y
C
C
h
h
a
a
r
r
g
g
e
e
r
r
will provide years of
dependable service. For maximum performance, manufacturer recommends:
• After each use, clean the battery charger clamps — be sure to remove any battery fluid that will cause
corrosion of the clamps.
• Clean the outside case of the charger with a soft cloth and, if necessary, mild soap solution.
• Do not allow liquid to enter the charger. Do not operate when charger is wet.
• Keep the charger cords loosely coiled during storage to prevent damage to the cords.
WWAARRNNIINNGGSS::
• Do not use charger if cords or clamps have been damaged in any way — call the Authorized Service Center
nearest you.
• There are no user-serviceable parts in this unit.
• Do not open the unit. In the event of malfunction, it must be returned to manufacturer for professional testing
and repair. Opening the unit will void the manufacturer’s warranty.
WARNING: The use of any accessory not recommended for use with this tool could be hazardous.
SERVICE INFORMATION
All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and
reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts,
contact the Black & Decker location nearest you.
SPECIFICATIONS
Input: 120 or 220V AC, 50 or 60Hz, 550W continuous
1500 watts engine start
Output: 12 volts DC, 2/10/30 amps continuous
80 amps engine start
Printed in China
188166-00
8/17/07