Filter
Top Products
12 VOLT DC ON-DEMAND PUMP
To extract water from your water tank, you need 12 volt-DC power to operate the
on-demand water pump. Energy for the pump is supplied by the auxiliary battery or
converter. Depending on your trailer model, the pump will be located under the bed, in a
cupboard, under the unit or under the sink. The switch to operate the pump is located on the
monitor panel or a wall near the pump.
Refer to instructions supplied by the pump manufacturer with your trailer. If you have
questions, consult with your independent, authorized dealer and/or visit the manufacturer’s
website at www.shurflo.com.
.
NOTE: The water pump switch should be in the off position when the camper is left
unattended for any amount of time. If something would happen to the water system,
this will help limit water damage to a smaller area.
WATER PRESSURE REGULATOR
Excessive pressure from water supply systems may be encountered in some parks,
especially in mountain regions. Water pressure regulators are available to protect your
system against such high pressure. A regulator of this type is recommended to prevent
damage to the plumbing system or component parts.
Caution: Not using a water pressure regulator when using city water may cause the
o-rings to blow. It is advisable to always use a water pressure regulator when using
the city water connection.
WASTE WATER DISPOSAL
Proper disposal of waste water is important. Most campgrounds and some states prohibit
waste water drainage onto the open ground. Refer to the information in the “Preparing to
Travel Home...” chapter for instructions on waste water disposal. If you have further
questions, consult with your independent, authorized dealer.
Jay Series/Baja/Select Folding Camping Trailer 53
Setting Up Camp...