Filter
Top Products
Screen Room Set Up
1. The canopy must be set up through step #3 before attempting to attach the screen
room. (See Canopy Setup.)
2. Open, unfold and spread the screen room under the canopy area. The enclosure must
be on the outside of the snap button poles. A grassy area or clean floor is suggested.
3. Each upper side panel has a pocket sewn into the fabric. Slide a two-piece tension
rafter into the pocket with the white crutch tip to be placed against the side panel of
the roof. Insert the crutch tip at the outer edge, and push in toward the unit.
4. Insert the peg through the “eye” of the snap button pole “B” and then through the
hole at the outer end of the end divider bar “C”. The white rubber crutch tip will rest
against the roof metal or the canopy bag. Install both ends.
5. Attach the Velcro hook sewn to the inner side of the canopy to the Velcro loop sewn
to the outer side of the screen room, full length.
6. Wrap the lifter post covers around the posts and attach them with the Velcro.
7. Ensure that all snaps are securely fastening the skirt to the frame of the unit.
8. Attach the Velcro from the skirt to the Velcro on the screen room lower corners.
9. Adjust the three snap button poles “B” so the bottom of the screen room is just
touching the ground.
10. Install the seven (7) stakes through the screen room loops to protect against wind
damage.
Heated Bed Mat (Option)
Your heated RV Bedding has been carefully designed and manufactured to provide years
of relaxing, comfortable sleep. The bedding is manufactured to reach gentle, soothing heat
warmth, NOT the pain relieving heat of a heating pad. At first touch it may seem only
slightly warm because it’s conserving energy inside for you, but as your body weight
presses onto the bedding, and a blanket covers you, it will feel considerably warmer and
comfortable.
Caution: Be sure to read all instructions carefully before using this bedding.
• YOUR BEDDING SHOULD ALWAYS REMAIN FLAT, NEVER FOLDED,
ROLLED OR BUNCHED. EXCESSIVE HEATING MAY OCCUR FROM
MISUSE.
• Place the bedding on the mattress, box spring or platform with the label and
connector up.
• The cord should be at the head of the bed.
• Do not tuck in the wired area of the bedding.
• Let the cord hang free - DO NOT route electrical cords between the heated RV
bedding and the mattress, box spring or base platform. Do not allow the cords to be
pinched. NEVER pull the mat by its cord.
• Keep the control away from an open window.
• Do not use pins or any heavy, sharp pointed objects on the bedding. They may
damage the heating elements.
• Be sure this bedding is used on 120 Volt AC circuit
• Turn off the electric current when this bedding is not in actual use.
50 Jay Series/Baja/Select Folding Camping Trailer
Setting Up Camp...