Axxess Interface Automobile Parts Automobile Parts User Manual


 
axxessinterface.com 800.221.0932
8
Manual Programming/SWC Button Reassignment:
If your vehicle is not listed for auto detection by the ASWC on the Axxess website most vehicles can
still be manually programmed to the ASWC by following these steps:
* Note: Not every radio will have all the possible swc commands on the steering wheel. Aftermarket
radios that do not have Bluetooth will not recognize the PTT (Push To Talk) or On Hook / Off Hook
commands, however those buttons can be manually programmed to do other commands. Please
refer to the radios owners’ manual or wireless remote for specic commands the radio will recognize.
1) Complete connections to the vehicle and the aftermarket radio, making sure the 3.5mm connector
is connected.
* If this is the rst time the ASWC is being installed in a vehicle:
2) Turn the ignition on; the led will start ashing rapidly
3) After 10 seconds the ASWC will go into the LED feedback mode. After the series of led ashes the
led will stay in a slow constant ash state.
Or
* If the ASWC has been in a vehicle before:
2) Press and hold the reset button down for more then 10 seconds.
3) After the 10 seconds the led will begin a slow constant ash.
4) At this point press and hold the Volume Up button on the steering wheel for 7 seconds until the led
goes solid red. Now release the Volume Up button and the led goes off. Volume Up has now been
programmed.
5) Now press and hold the Volume Down button until the led goes solid red. Release the Volume
Down button and the led goes off. Volume Down has now been programmed.
6) At this point press and hold the next button on the steering wheel that corresponds with the
programming list (see below). The chart below shows in what order the steering wheel control
buttons need to be programmed in.
If the next function on the list is not on the steering wheel press and hold the Volume Up button for 1
second till the led comes on then release the button. This tells the ASWC that the function is not avail-
able and moves on to the next function.